Self-Clinching Fastener Installation

A thread in sheet metal without welding. A self-clinching fastener is pressed cold into a pre-cut hole: the hydraulic press forces it in, the material around the hole is displaced, and the fastener stays mechanically locked in the sheet itself. The part leaves with a finished thread — no weld spot, no heat distortion and no rework afterwards.

What we install

  • Self-clinching nuts — a thread where the sheet is too thin to carry a welded nut.
  • Studs and bolts — a captive stud projecting from one face of the panel.
  • Standoffs — to hold a PCB, a second sheet or a panel at a fixed distance.

Thread sizes run from M2 to M8.

Materials

  • Steel
  • Stainless steel
  • Aluminium

The machine

  • Insertion force up to 57 kN — roughly 5.8 tonnes.
  • Automatic pneumatic fastener feed — the fastener arrives in position by itself, so the operator only holds the part.
  • Hydraulic drive — the force builds smoothly instead of landing as an impact.

The right fastener comes from the catalogue

Hole diameter and minimum sheet thickness are not the same for every fastener. Both are read off the specific part code in the TR Fastenings and SARIV catalogue — 111 families with sizes, hole diameter and its tolerance, minimum sheet thickness and the equivalent code at the other manufacturer. We check this before the part goes to the laser, because the hole is cut in the same operation.

When this beats welding

Galvanised sheet. We do not weld galvanised steel — not robotically, and not by MIG/MAG, spot or stud welding. A galvanised part is joined with rivets, with press-fit fasteners or with bolts, and this process is one of those three routes.

Visible surfaces. The insertion is cold, so there is no discolouration, oxide or heat mark on stainless steel or aluminium on the reverse of the panel.

Thin sheet. A welded nut puts heat into a small area and pulls the panel out of flat; a clinched fastener puts in no heat at all.

The other permanent joining methods have their own pages: riveting and robotic welding. Parts that take press-fit fasteners are cut on the laser and bent on the press brake within the same order.