Alongside the robotic cell we also weld by hand. Manual welding takes the part that is a one-off, non-standard or simply too fine for a robot. The three methods are not interchangeable — the choice follows how the seam has to look and how fast the job has to be done.
TIG welding
The most precise way to join two metals without it being obvious that they were ever joined.
- When: when the seam is visible and has to look right — thin parts, fine assemblies.
- Materials: stainless steel, aluminium, thin mild steel.
- Galvanised: possible, but only after the zinc layer is ground off the weld area.
- Result: a clean, narrow, precise seam with minimal spatter.
- Speed: the slowest of the three — precision takes time.
- Appearance: neat and evenly stacked.
MIG/MAG welding
The workhorse of welding — not the most elegant, but it gets more done in less time.
- When: structures, frames, housings, thicker parts, series production.
- Materials: mild steel, stainless steel, aluminium.
- Galvanised: possible, but only after the zinc layer is ground off the weld area.
- Result: a strong, fully fused seam with good load capacity.
- Speed: fast — the default method for volume.
- Appearance: slightly coarser than TIG, perfectly presentable once dressed.
Spot welding
No wire, no gas, no fume — just two electrodes, pressure and current.
- When: overlapping thin sheets — boxes, enclosures, covers.
- Materials: thin sheet — mild, galvanised and stainless steel.
- Galvanised: welded directly — two pulses: the first burns the zinc away at the spot, the second makes the weld.
- Result: discrete, almost invisible joints with minimal distortion.
- Speed: the fastest method — seconds per spot.
- Appearance: practically invisible from the outside.
Laser welding
Laser welding — for thin, fine parts where the seam should show as little as possible. We use it on thin stainless steel and aluminium sheet, small assemblies and decorative elements (channel letters, thin-walled enclosures and the like), where conventional welding would distort or scorch the part.
The beam is narrow and precisely aimed, so the heat input stays minimal — no warping, no darkening around the seam. The result is a clean, smooth seam that needs almost no dressing afterwards.
It is not for thick steel or large structures — that is work for manual or robotic welding; here finesse wins, not force.
Galvanised sheet — directly on the spot welder only
Galvanised sheet can be welded, but not the same way by every method. It goes onto the spot welder directly: the two-pulse technology burns the zinc coating away at the spot itself and makes the weld in the same cycle. TIG and MIG/MAG are possible too, but the zinc layer has to be ground off the weld area first. When a part must not be welded at all, rivets, self-clinching fasteners or bolts remain.
When the volume grows
A repeating seam in a production run is not made by hand. At that point the work moves to robotic welding — a 7-axis robot with two rotary positioners, where every part in the batch gets the same seam rather than a seam that depends on the welder's day.
The individual methods have their own pages as well: MIG welding, MAG welding, spot welding and stud welding. After welding come the finishing processes. Parts are cut on our laser and bent on the press brake within the same order.